Cleft Grafting a Avocado Seedling to 'Krueger Seedless'

Grafting avocados can be as complicated as you want to make it, but simple methods will give you the best results. This trial logs the process of grafting an avocado seedling to the 'Krueger Seedless' cultivar using a standard cleft graft, along with the 3-month results.

Prep:
The process starts with the scionwood, 'Krueger Seedless'. I cleaned off any remaining leaf stems. Some snap off easily depending on the freshness of the wood. Apical buds can be too tender and problematic on some scions, so I always remove them in favor of fat lateral buds. Now that the scion is cleaned up, I gently wrap the scion with parafilm from the bottom up, starting about an inch above the base of the scion to allow for easy cutting. Once my scion is prepped, I move to the seedling rootstock. I start high by removing the top of the seedling with the bulk of the foliage to see what I’m working with. Then I cut the rootstock back a bit lower down where the stem caliper better matches the scion.

Cuts:
To make the cleft graft, I first split my rootstock. I set my grafting knife over the center of the rootstock with my right hand. I hold the rootstock with my left hand as if to click a pen and place my thumb over the spine of the blade and gently press down while using my right hand to gently rock the grafting knife and slide the knife down blade deep.

Once my rootstock is prepped, I grab my scion like a drumstick or wand and hold it firmly in my right hand, leaving the exposed end of the scion extending past my thumb and index finger. With my left hand, I bring in the grafting knife with the blade facing up and start with the flat side of the blade parallel to the scion, and I shave the end of the scion into a wedge.

Setting the Graft:

Now that my rootstock and scion are ready, I set the scion into the rootstock cleft at a slight angle to ensure solid cambial contact along the side, letting the back edge protrude just a fraction. To lock it down, I applied a layer of parafilm starting below the graft, wrapping upward under firm tension to seal the graft and prevent desiccation. This may be the most important part. I use a grafting rubber band to increase tension and force the plant tissue together. I start by anchoring it low with an overlap, wrapping upward over the union under high tension, and securing it with a terminal loop. This is your graft completed.

Aftercare:
Keep your fresh grafts in dappled light and out of extreme conditions. Shade cloth, tree paint or a spot with mild conditions are ideal to get your graft healed. Depending on rootstock vigor and the condition of your scionwood, you can see buds break the parafilm in a month, but seeing budbreak is not a guaranteed sign of success. It’s once those buds extend that you know you have a good graft.

3-Month Update: Checking back in later in the summer, the union healed out cleanly and the scion has pushed a strong, vigorous flush of new growth.

Watch the video breakdown and summer update: How to Graft an Avocado Tree | Krueger Seedless Avocado (With Update!)

Next
Next

Jim Rider’s Red Flesh Apples